Buy now viagra

How effective is testosterone in treating erectile dysfunction? In patients with hypogonadism, testosterone treatment can improve libido and erectile dysfunction, but the response of erectile dysfunction in men with hypogonadism to testosterone is not complete; many men still may need additional oral medications such as sildenafil, vardenafil, or tadalafil. online apotheke levitra kaufen buy levitra Buy now viagra So, even if the nerves or blood vessels going to your penis are not working so well, a tablet can cause the blood flow to increase in your penis, and cause an erection. Tablets can treat ED caused by various underlying conditions. Note: none of these tablets will cause an erection unless you are sexually aroused. What are intracavernosal injections? Medications can be injected directly into the corpora cavernosa to attain and maintain erections. Medications such as papaverine hydrochloride, phentolamine, and prostaglandin E1 (alprostadil) can be used alone or in combinations to attain erections. Combining small amounts of each drug is preferred over using a single drug because of increased efficacy and fewer side effects. Even though such injections can be effective in the management of erectile dysfunction (success rate of around 80%), they are not widely used because of their potential complications. These injections are painful, can cause scarring of the penis, and have a higher risk of developing priapism. viagra online dangers buy viagra Sexual Problems in Men:While research suggests that sexual dysfunction is common (43% of women and 31% of men report some degree of difficulty), it is a topic that many people are hesitant to discuss. Fortunately, most cases of sexual dysfunction are treatable, so it is important to share your concerns with your partner and doctor. Buy now viagra Inflatable implants consist of paired cylinders, which are surgically inserted inside the penis and can be expanded using pressurized fluid (see figure 3). Tubes connect the cylinders to a fluid reservoir and pump, which also are surgically implanted. The patient inflates the cylinders by pressing on the small pump, located under the skin in the scrotum. Inflatable implants can expand the length and width of the penis somewhat. They also leave the penis in a more natural state when not inflated. Buy now viagra A recent study suggests an epidemiological association between chronic periodontitis (periodontal inflammation) and erectile dysfunction, similarly to the association between periodontitis and coronary heart diseases, and cerebrovascular diseases.[17] In all the three conditions (erectile dysfunction, coronary heart disease and cerebrovascular diseases), despite the epidemiological association with periodontitis, no causative connection has proved yet. Erectile dysfunction (ED), also known as impotence, is the inability to get and maintain an erection that is sufficient for satisfactory sexual intercourse. buy generic cialis online australia buy cialis online
Bring It Back Home
Written by DOLLS Publisher, Joe Jones   

It’s time to encourage manufacturers to bring the production of their collectible dolls and teddy bears back to the USA.

It’s time to encourage manufacturers to bring the production of their collectible dolls and teddy bears
back to the USA. For the past two decades, and especially in the past 10 years, manufacturers have
been closing down U.S. manufacturing plants and producing their collectible teddy bears and dolls
in China as a cost-savings measure, allowing them to cope with the declining interest in new-issue
collectibles. This short-term savings is now producing long-term problems, which can be resolved
by bringing the manufacturing process back home.


This overseas production has resulted in the following pitfalls:


1.  Loss of quality control. While there are certainly quality pieces produced throughout the world, the overall mass production has resulted in a loss of the high quality finishing that collectors have come to expect. Steiff, the premier collector teddy bear company, has recently pulled all its manufacturing out of China and back to Germany because of this issue. Astute collectors know quality, demand quality, expect quality and are willing to pay for it.


2.  Loss of American jobs. When dolls and bears are manufactured outside of the U.S., jobs that would normally be filled by Americans are being performed by others and while there may be a cost savings in the short run, it is Americans in general who are the losers in the long run. Today nearly two-thirds of those manufacturing jobs have been lost to China in the past decade.


3.  Loss of collectible appeal. American collectors prefer American-made products and new-issue material produced in China does not attract the same enthusiasm that the U.S.-made products will produce.


4.  Loss of the ability to generate new collectors. When a company employs a large staff, those working in the plant create collector interest just by their pass-along comments. Each American touches hundreds of other lives, and nearly all their contacts are aware of their job status. So, by working in a doll or Teddy Bear factory, the word spreads and new collectors are created.


In addition, the cost-savings factor, which drove these manufacturers overseas originally, has dwindled so that it’s no longer a major factor for survival in today’s economy. Yes, there may be some savings, but the problems created from this move (as listed above) clearly trump the decision to continue overseas manufacturing.


The doll and teddy bear collector market is a market with a future. It’s time the U.S. doll companies consider returning to manufacturing their products at home. It’s a better future for everyone.

Buy now

TrackBack URI for this entry

Buy now

Subscribe to this comment's feed

Buy now

smaller | bigger

busy